Component Type: kbuild config

Description: Atmel WILC1000 SDIO (WiFi only)

More info: This module adds support for the SDIO interface of adapters using WILC1000 chipset. The Atmel WILC1000 SDIO is a full speed interface. It meets SDIO card specification version 2.0. The interface supports the 1-bit/4-bit SD transfer mode at the clock range of 0-50 MHz. The host can use this interface to read and write from any register within the chip as well as configure the WILC1000 for data DMA. To use this interface, pin9 (SDIO_SPI_CFG) must be grounded. Select this if your platform is using the SDIO bus.

Build project: Kconfig (Linux kconfig) (Path: drivers\net\wireless\microchip\wilc1000\Kconfig )

Other views: file explorer